To avoid serious or fatal injury, turn the ignition on, then reconnect the battery. To avoid serious or fatal injury, do not place an intact undeployed Left Seat Squib Airbag face down on a hard surface, the airbag will propel into the air if accidentallyĬheck connectors – Clean and repair as necessary.Ĭonnect the 8443 Load Tool and 8443-1 Jumper to the Left Seat Squib Airbag connector. To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.ĭisconnect the Left Seat Squib Airbag connector. CHECK FOR SHORTED SQUIB CIRCUITS AT THE LEFT SEAT SQUIB AIRBAG The scan tool, SRS Airbag Load Tool MRL 8443, and DVOM are required to perform the following test.Ģ. (R33) LEFT SEAT SQUIB LINE 2 CIRCUIT SHORTED TO GROUNDĮnsure that the battery is fully charged. (R31) LEFT SEAT SQUIB LINE 1 CIRCUIT SHORTED TO GROUND The ORC will set this DTC if it detects low resistance of the Left Seat Squib circuits. Set Condition:The Occupant Restraint Controller (ORC) monitors the resistance of the Left Seat Squib circuits.For a complete wiring diagram Refer to Section 8W.
0 kommentar(er)
